create equipment (pump -1)

PUMP-1
CREATE > SOLID
TYPE > CYLINDER > APPLY
HEIGHT = 100; DIAMETER = 350; Z-AXIS = E > OK

TYPE > CONE > APPLY
D-TOP = 100; D-BOTTOM = 200; HEIGHT = 100; Z-AXIS = E > OK
CONNECT > PRIMITIVE > ID POINT

TYPE > CYLINDER > APPLY
HEIGHT = 75; DIAMETER = 100; Z-AXIS = E > OK
CONNECT > PRIMITIVE > ID POINT

TYPE > CYLINDER > APPLY
HEIGHT = 125; DIAMETER = 150; Z-AXIS = E > OK
CONNECT > PRIMITIVE > ID POINT

TYPE > CYLINDER > APPLY
HEIGHT = 75; DIAMETER = 100; Z-AXIS = E > OK
CONNECT > PRIMITIVE > ID POINT
TYPE > CONE > APPLY
D-TOP = 150; D-BOTTOM = 200; HEIGHT = 25; Z-AXIS = W > OK
CONNECT > PRIMITIVE > ID POINT

TYPE > CYLINDER > APPLY
HEIGHT = 300; DIAMETER = 200; Z-AXIS = E > OK
CONNECT > PRIMITIVE > ID POINT

TYPE > CONE > APPLY
D-TOP = 150; D-BOTTOM = 200; HEIGHT = 25; Z-AXIS = E > OK
CONNECT > PRIMITIVE > ID POINT

TYPE > PYRAMID > APPLY
Y-TOP = 0; X-TOP = 100; Y-BOTTOM = 350; X-BOTTOM = 100; Y-OFFSET = 0; X-OFFSET = 0; HEIGHT = 175; Y-AXIS = N; Z-AXIS = U > OK
BY D 87.5

TYPE > PYRAMID > APPLY
Y-TOP = 0; X-TOP = 300; Y-BOTTOM = 200; X-BOTTOM = 300; Y-OFFSET = 0; X-OFFSET = 0; HEIGHT = 175; Y-AXIS = N; Z-AXIS = U > OK
BY D 87.5
POSITION > MOVE > TROUGH > DIRECTION N > THROUGH ID CURSOR > APPLY
OR USING COMMAND MOVE E THR ID@ ENTER
SELECT CYLINDER PUMP MOTOR

TYPE > BOX > APPLY
YLENGTH = 400; XLENGTH = 1000; ZLENGTH = 100
Y-AXIS = N; Z-AXIS = U > OK
BY E 350 D 225

CREATE > SOLID
TYPE > NOZZLE > APPLY
FILL IN THE NAME OF NOZZLE IN NAME COLUMN
SELECT NOZZLE TYPE
SPECIFICATION = #150 R.F.
GENERIC TYPE = ANSI _FLANGED
NOMINAL BORE = 80
APPLY > DISMISS
ORIENTATE P1 IS = W
HEIGHT = 100
APPLY > DISMISS
CONNECT > PRIMITIVE > ID POINT

CREATE > SOLID
TYPE > NOZZLE > APPLY
FILL IN THE NAME OF NOZZLE IN NAME COLUMN
SELECT NOZZLE TYPE
SPECIFICATION = #150 R.F.
GENERIC TYPE = ANSI _FLANGED
NOMINAL BORE = 80
APPLY > DISMISS
ORIENTATE P1 IS = U
HEIGHT = 250
APPLY > DISMISS
BY U 250 N 100

TYPE > DISH > APPLY
DIAMETER = 100; HEIGHT = 50; RADIUS = 10; Z-AXIS = U > OK
DIAMETER = 100; HEIGHT = 50; RADIUS = 10; Z-AXIS = D > OK
OR CREATE > COPY > MIRROR

MODIFY > EQUIPMENT ORIGIN > ID POINT
SELECT DISH POINT